nuboot
RidnClean
5,000+ posts
Love 4 Money
my friend runs one that low(silver cased) so yeah i'd say its possible.
deathpenalty18
10+ year member
get r done
if the coils are dual 1.4 then run the amp in 2ohm????? so wire each sub ta 2 ohm so it will do around 3k each!
Enellz
10+ year member
The Triple O.G.
You should be fine, with proper electric
deathpenalty18
10+ year member
get r done
oh what sub?? u have to had a pritty good electrical if ur going to be doing that. and its going to be more than 3k
Annnarbor84
5,000+ posts
Banned
So I am assuming two subs. Dual 1.4 should be .7 or 2.8 if my math is correct. You will not be able to run these amps @.7:fyi:
Even with rise it is still to low.
They are two channel amps??? If so run one amp to a sub. Wire each coil to a channel.
Annnarbor84
5,000+ posts
Banned
Will not gain anything from doing this. 2ohm bridged or 2 channels@ 1ohm...
Cabin_Pressure
10+ year member
yeah, it'll do
Run one amp to each coil. What is the complication? Gonna be funny watching ~3k per coil..................for a few seconds anyway:laugh:
yea its not a level 5 or anything. its just an atomic 10 dude. 6k would be overkill. find an amp that does power at .7 (1ohm)
Annnarbor84
5,000+ posts
Banned
will one on each sub work
Hard to tell bud:laugh: That sub will not take two of these amps daily. If you are into that burp shit, then yes it should take the two alright. Yes the 1.4 ohm load on each amp is fine, I run mine @ 1 ohm with no problems.
Cabin_Pressure
10+ year member
yeah, it'll do
One Ap at 2.8ohms would be enough for that sub daily. Try two if it's burps, post vids.
Activity
No one is currently typing a reply...
Similar threads
About this thread
