1999 Ford Expedition sub amp replacement

  • 1
    Participant count
  • Participant list

goiby

Junior Member
I am trying to install an amp in my 99 expedition. I have 5 wires to work with, black-orange, green-purple, red-black, black-green, and light green-black. I have listed below what I have on each and what I beleive they may be. Please let me know if I am even close on this. Don't want to burn something up.Thanks!

Black-orange= audio (-) 4.97vdc this wire and the red-black are in a foil sheid with a bare steel color wire.

red-black= audio (+).077vdc

green-purple= 7.31vdc No clue? Help!

light green-black= 12vdc

black-green= grd

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Are you planning on reusing the power pack? If yes cut the wires at the top red arrow only. Connect your new radio harness to the translucent one...
1
906
Yep, that will mark the third iteration of teh X series. i figured that was in the loop as they have been running out of stock on the last...
11
686
Ahhh, I had it in my head that it was 1 ohm stable for some reason.
41
3K
One fuse (the 300) goes close to the battery to protect the power wire...then close to the amp you'll add another fuse (whatever size the...
29
4K
It is in eBay. It is a bit more complicated. You clip off the gray blocks on your radio's harness and splice in the new harness by color matching...
7
1K

About this thread

goiby

Junior Member
Thread starter
goiby
Joined
Location
Gosport, In
Start date
Participants
Who Replied
Replies
0
Views
1,833
Last reply date
Last reply from
goiby
1000008028.jpg

Mr FaceCaser

    May 20, 2024
  • 0
  • 0
1000008027.jpg

Mr FaceCaser

    May 20, 2024
  • 0
  • 0

New threads

Top