SOLD 12" RE SX and Alpine MRV-1507

[phantom240 5,000+ posts]

Since i cant edit my original post in my old thread, Im selling my used RE SX, its a 12" dvc 2 ohm... has a few scuffs on the surround. Im looking to get $140 plus shipping.-SOLD!

I also have for sale my prized amp, my Alpine MRV-1507. Its a class A/B amp, pushing over 900w RMS bridged at 4 ohms. Amp has very clean power output and has never ONCE shut down on me. Even while bumping for over 4 hours straight. Awesome amp. Looking to get $200 shipped. Heres a pic next to my old MRV-T757. I WOULD keep it, but ny new system is going to be run at 2 ohms, which in bridged mode this amp isnt stable. Its not the prettiest amp, but for the most part its in good cosmetic condition.

Also willing to trade for a nice amp that does approx. 1000w - 1200w at 2 or .5 ohms.

Click to read more...

 

[phantom240 5,000+ posts]

Ttt

 

[phantom240 5,000+ posts]

Bump

 

[Hintzyboy 5,000+ posts]

what does the alpine put out at 4 0hm stereo?

 

[almond 10+ year member]

do you have a paypal account?? that would affect my interest in the sx.

 

[dleccord 5,000+ posts]

i want that amp 1507 bad.

 

[phantom240 5,000+ posts]

what does the alpine put out at 4 0hm stereo?

Lots. Lemme pull up the PDF user's manual.

Power Output: RMS Continuous Power (at 12.0V, 20 Hz to 20

kHz)

MRV-1507

Per channel into 4 ohms ......................... 150W, 0.08% THD

Per channel into 2 ohms .......................... 300W, 0.3% THD

Bridged into 4 ohms ................................ 600W, 0.3% THD

Power Output: RMS Continuous Power (at 14.4V, 20 Hz to 20

kHz)

MRV-1507

Per channel into 4 ohms ......................... 225W, 0.08% THD

Per channel into 2 ohms .......................... 450W, 0.3% THD

Bridged into 4 ohms ................................ 900W, 0.3% THD

Max. Power (at 14.4V)

MRV-1507

Per channel into 4 ohms ............................................ 450W

Bridged into 4 ohms ................................................ 1500W

Frequency Response ................... 10 Hz to 50 kHz (+0, –1 dB)

Signal-to-Noise Ratio

(referenced to rated power) ........................................ 105 dBA

Slew factor ........................................................ Greater than 5

Damping factor

MRV-1507/MRV-757 ................................ Greater than 500

Input Sensitivity (for rated power

output) ........................ 200mV to 4.0V (1.0V at center detent)

Input Impedance ....................................... Line in: 10k ohms

Speaker Impedance ............................... 4 or 2 ohms (Stereo),

4 ohms (Bridged)

Active Dividing Network Frequency and Slope

MRV-1507/MRV-757 .......................... LP: 30 Hz to 200 Hz,

24 dB per octave (MONO) (Hella crossover slope!)

Power Requirement .................. 11 – 16V DC Negative Ground (16v, damn skippy!)

Dimensions (W x H x D)

MRV-1507 ............................... 260mm x 60mm x 530mm

(10-3/16" x 2-3/8" x 20-7/8")

God only knows how much you would get out of it with 16v.//content.invisioncic.com/y282845/emoticons/naughty.gif.94359f346c0f1259df8038d60b41863e.gif

do you have a paypal account?? that would affect my interest in the sx.

I would rather not use it, but yes i do. If thats what makes the sale, then so be it.

i want that amp 1507 bad.

//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[almond 10+ year member]

ok i have one other sub i'm looking at, if that doesn't go through i'll pm you for your paypal addy and i'll pitch in a couple bucks for fees.

 

[phantom240 5,000+ posts]

Thats fair. keep me updated.

 

[phantom240 5,000+ posts]

Forgot to add. The amp has one terminal stripped. I WILL repair it by using a helicoil before it is sent.

 

[almond 10+ year member]

**** i thought it was shipped, can i get a shipping quote to 85248??

 

[phantom240 5,000+ posts]

One step ahead of ya. Just about anywhere is going to run about 25 bucks.

 

[almond 10+ year member]

hmmm.... really tempting, i'm also looking at an mmats dreadnaught and p3.0. i just don't have a guaranty that they work. but, thats still in my price range. eh screw it, go ahead and pm me your paypal addy.

 

[phantom240 5,000+ posts]

Hit me up with offers or trades. I need an amp that will do about 1000 at 2 or .5 ohms

The mmats isnt a bad sub either... but that p3 is a pile of ****. Rockford has produced nothing but garbage for like the last 6 years.

 

[almond 10+ year member]

sx is sold!!