10 / 12" Line "Below" E Series ?

[Spooney 10+ year member]

Pretty excited for this line of drivers. Going to make it possible for guys without a ton of cash to get some good drivers and also make it inexpensive to do a big cone area build

 

[Spooney 10+ year member]

Did some heavier abuse testing yesterday.
Ended up breaking the solder joint from the tinsel lead wires to voice coil lead at the neck joint on one side -- but did not actually break the neck joint or thermal the coil. Had it up around 550-700 watts clamped at the point of my testing before that failure occurred.

These samples have tied-on leads and actually the "floating" leads would have prevented this type of failure as it was a result of excessive forward stroke tugging the tied lead out of the hole it passed through -- and of course I was doing 550-700 free air on a 300-watt rated driver anyway so I can't say I am disappointing //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

Either way I have some Rev.2 prototypes in the works to address the high Qts and a few other minor things I want to improve. I have been spending alot of time as well making sure I can still offer them for the $60-70 range or VERY close to it //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

How soon could these drivers actually be available? Are you shooting for these to be happy in both ported and sealed enclosures?

 

[sundownz Pro Seller]

Once I get the drivers completely finalized production time is ~90 days from start to arrival here.

My goal is a mid Qts so ported or sealed.

 

[Chevy Blazin' 10+ year member]

Once I get the drivers completely finalized production time is ~90 days from start to arrival here.
My goal is a mid Qts so ported or sealed.

what's the cost on the E-Series 8's?

 

[Spooney 10+ year member]

what's the cost on the E-Series 8's?

SSA Shop - Sundown Audio E8 sub woofer

 

[sundownz Pro Seller]

Second round of prototypes are done at the factory; I have a 3rd round in the works as well for testing comparison purposes :

 

[globalminds_ent 10+ year member]

Poly cone?

 

[CaptainMaximus 10+ year member]

That cone looks just like a blacked out Boston acoustics g2 and g3 subs. But, I love that design!!

 

[michaellane 5,000+ posts]

Second round of prototypes are done at the factory; I have a 3rd round in the works as well for testing comparison purposes :

what if there is not a dealer local to us? also will you be making a $15? if so what will the price on that be?

 

[Spooney 10+ year member]

Second round of prototypes are done at the factory; I have a 3rd round in the works as well for testing comparison purposes :

I like the standard dust cap over the inverted one personally. Liking the progress. I may end up with a set of these myself.

 

[05trailblazer 10+ year member]

are these out yet?

 

[Spooney 10+ year member]

What ever happened with these Jacob?

 

[Spooney 10+ year member]

These little guys fell off the radar

 

[Full Tilt 10+ year member]

These little guys fell off the radar

Seems like a few Sundown products have suffered the same fate recently.