Recent content by yo0123yo

That's what I said at first and it is just a TAD bigger than the holder (length with) thats not a problem you can just cut some plastic away and install more support since it weighs 60 pounds lol

Awesome! The Kinetik HC-2000 has 1500 cranking amps and the Optima Red Top has 800 cranking amps. After swapping to the Kinetik will I most likely notice a big difference especially since now the car struggles to start especially since it is cold outside as well as easing the dimming when...

Yes, the alternator is stock. Is that bad if I swap to the Kinetik with a stock alternator? We looked at replacing the stock alternator to a high output alternator but they are just too expensive. Car is a 2005 Chevrolet Equinox if that matters lol. My buddy is a mechanic and a huge car guy so I...

Ok so recently I removed my two Kinetik HC-2000's from my trunk which I had powering my two Kicker 12" L7's along with a ZX2500.1. Now the car struggles to start every time especially since it's cold too. I looked at the front Optima Red Top and it had a couple of bulges as well so we know it...

Well I just reset it and this time it works now. The past couple resets didn't work for some reason.

First of all my system set up is two 12" Kicker L7's powered by a ZX2500.1 and for my pioneer interiors I have a ZX350.4 powering those. Last night everything sounded fine and seemed to be working as normal. This morning I turned my car on and on my DNX 6960 screen it says "DC Offset Error" in...

My system consists of 2 12" Kicker L7's powered by a ZX2500.1 and then I have 4 interior Pioneer speakers (can't remember which ones, as they were bought 2 years ago) powered by a ZX350.4 and then I have a Kenwood Excellon DNX6980 as the head unit. Before this head unit I had a pretty good...

I bought the sd card with the update on it and it was mailed to me but nothing is happening when i stick the small sd card in to my dnx6960 unit...Is there any option on the head unit to go to after putting the sd card in the head unit?

thanks so what you both have told me is eventually the same? also the wires that connect to the amp do they go to each sub or to only one sub?

I have the speaker wire and all the power necessary for these i just dont know how to wire the subs inside of the box or how to wire them together...can anyone tell me step by step how to wire these to a 2 ohm load please.. thanks...i saw some diagrams online and tried but all that did was...

anyone now maybe familiar with this or similar devices?

no one at all?

anyone?

.....

Kenwood KNA-NT100 NAVTEQ Traffic Tuner (KNANT100) i just purchased that for my dnx6960 so add add a perk to my navigation thats already there but i have seen no reviews on this product, anyone familiar with how it works and if it is real accurate? thanks