Kenwood DNX6960 staying at "DC Offset Error" "Protect" and my amps wont turn on!

[yo0123yo 10+ year member]

First of all my system set up is two 12" Kicker L7's powered by a ZX2500.1 and for my pioneer interiors I have a ZX350.4 powering those. Last night everything sounded fine and seemed to be working as normal. This morning I turned my car on and on my DNX 6960 screen it says "DC Offset Error" in the upper left hand corner and it says "protect" right in the middle. I cant even access my GPS due to this, I have no idea what is going on. Also I checked both of my amps and they are not turning on at all. Can it have anything to do with the fuse under the hood? Thanks so much I dont know what to do never encountered anything like this. Thanks!!!

Click to read more...

 

[yo0123yo 10+ year member]

Well I just reset it and this time it works now. The past couple resets didn't work for some reason.

 

[maylar 10+ year member]

Typically that error is due to bad voltages being on the HU speaker lines. Could be a speaker wire being shorted too ground or one of the internal amp channels is having issues.