Recent content by taylor

kay thanks

helotaxi, i am looking in your direction

PPI art series a200, i bought it for 50 bucks, the guy thought it was old junk!!!!!!, now, who knows what set of terminals are used to bridge the thing???? i have a 4 ohm mono load i need bridged, the terminals are as marked left-, left+, turn on, Right + Right -.......no clue which set of +...

hmmm, this is tough....i'd almost have to hear the car itself to diagnose the prob.

boxes are for *******......just like mufflers.

i prefere just to ley my sub sit right on the floor of my trunk.... Boxes are gay....

buy an alpine h/u with a changer...good luck getting that to skip....

try turning your x-over down, i thought i read you had it set at 80hz, try lower....like 60/50 hz.

did you check your fuse panel? check to see if there is any blown fuses in there.

yes, it will hold it's source voltage. Dont short out the terminals together....or the + to ground.

meh................

i'd go rotary for sure

i usually do, i say go for it!

so big and thick the rolls have to be unloaded with a crane of sorts....they call it flexable...if you can cut off a foot of it and use it to smash out windows and kill someone, i don't call it flexable....or if you need a 2 foot piece of ridgit conduit to make it bend where you want it to...

go Shiva man, for sure, 200watts would be ample for it in a truck!