Recent content by ps2cho

So I took a look today and it does appear the bass boost was set at 5db so I turned that off, which helped a lot. Not as clean as something bigger, but I think you guys are right in that its the size of the box...but I want to balance maintaining the size of the trunk. If I wanted to see how it...

Hi all, System: JL Audio JX500/1d Amplifier JL Audio 8in subwoofer CP108LG-W3v3 AudioControl LC2i (factory sub disconnected and wired up to Lc2i) KnuKonceptz 8 gauge wiring kit I find that the bass overall is very deep and it hits hard, but it goes way too "boomy" or vibrates hard on certain...

Overall equipment installed in my 2016 Audi A4 Audiocontrol LC2i (installed in-place of the factory subwoofer speaker wires. so Factory sub -> LCI -> Amp -> Subwoofer.) JL Audio JX5001/d Infiniti 8" 850w Subwoofer in custom box, 22 x 15 x 4.5" which equals ~0.50cf KnuKonceptz 8...

Hi guys, I have a 2016 Audi Allroad with the factory Bang & Olufson 15 speaker setup. Overall sound quality is pretty good, but the subwoofer in the trunk is basically inaudible. I want to add an amplifier and enclosure /w subwoofer to the system to get the bass I need. I'm not looking for...

Gotcha. Thank you for the explanation. As with everything, there is the right way to do it, and the wrong way to do it. I have my CPU at 4.5GHz, but I am running a high end cooler, and keep the voltage under control -- I've done this for years and as long as you do it right, no problems. Its a...

Yes, I understand that. My i5-2500k CPU is designed stable at 3.3GHz, but I run her at 4.5GHz.... Whats the deal with running at 2ohms 2 subwoofers bridged.

My amp: 2-channel car amplifier 100 watts RMS x 2 at 4 ohms (145 watts RMS x 2 at 2 ohms) 290 watts RMS x 1 in bridged mode (4-ohm stable in bridged mode) Subs: 2x Alpine SWE-1043 250w RMS 750w max 4ohms Whats the implications of running both of these bridged in the amp in 2ohms? Is it...

Thanks for input guys.... How can I find the volume of each chamber? I know volume of triangle is 1/2 B*H, so the height according to my calculations is 13.25" 38.95125 = A of triangle * 21 length = 818^3 inches / 12 = 68^3 ft. Does that sound right?

I made my own custom box that fits between rear seats in my wagon.... Currently have some terrible 10" DUAL 300W subs. They just ****, but worked fine for a number of years when I didn't really need much bass. Whats some good subs that will fit this box? Something under 300W RMS will be plenty...

This is my stuff: http://www.crutchfield.com/p_10951202BR/JBL-GT5-1202BR.html?search=JBL+VENDORID109&ssi=0&searchdisplay=JBL + http://www.crutchfield.com/p_070XPA2500/Dual-XPA2500.html?search=xpa2500&ssi=0&tp=115 Running bridged.

Yeh... Oh you know what...Does the car have to be started or just ignition ok? I remember reading that somewhere...

Okay I used a 50Hz test tone and the highest it would read was 16.1v...so I'm all good right?

So I have a 12" JBL GT5 sub running on a dual xpa2500 @ 150W RMS bridged. Yeh amp is cheap, but it does what I want for the price. I would like to set the gains correctly although from what I have read I am very unlikely to damage the sub because it is rated for 275W RMS and I am running it at...

Opinions noted... The issue is that my floor has a mat and under that its not bare metal...so how could I install L brackets? I'm just looking into all my options.

Anybody know the best Velcro to use that will hold my box down tight? And then where to find it? Brick+Mortar stores preferred... Thanks.