Recent content by noelalberto8

Yeah that's the plan, it's has more than enough spaces to drill on looking from the outside. When I take it out completely hopefully is the same case on the other side of the plug.. Hopefully I could drill around the molex and not around where the wires are connected.. Thank you

Bow that I'm doing it, it's easier than I thought. I order a set of 6 angle pick tool to aid on the removal of the back clip.. It should arrived tomorrow.. It should be a done deal in Saturday.. Thanks everybody for the advices

What do you mean to fish it with a p3 long + screw driver? I managed to removed the rubber grommet but didn't have much luck removing the molex from the body hole.. The side that is attach to the car body is blue and the part that does back to the car door is white. On the top and bottom it...

I was thinking about doing that but under the grommet there's a molex.. Any other ideas?

Hello, I already have aftermarket speakers on all four doors and subwoofer connected to an amp. The speakers are amplified through the factory wiring through the back of the after market receiver. Now i'm planning on buying pro components speakers rated at 150RMS, which is too much power for the...

Need help. I currently have install a 5 channel amp. With two pair of Polk audio db651 and a 12 inch subwoofer.p, kenwood dpx500bt. When It was first installed it the speakers sounded so loud and bright that it made my ears hurt at 3/4 of the volume. After a few months now the speakers sound...

the amp is actually under rated based on a bench mark video i seen on sonic electronix, it really puts out 500rms @ 2ohm on the sub channel. I'm sort of new at this. Lets say i decide to tune it by ears will I be using the "level" knobs for the rear, front and sub. Lets say, i'm setting the...

Need help setting the gains on My 5 channel amp.

That's the wiring diagram for the aftermarket fog lights. Which wire will I splice to OEM FOG WIRE..

The factory harness has four wires but the harness only uses 3. The fourth wire is for the fog. I was told that I could either buy an f-harnessto connect or splice into that fourth wire. I rather splice the fourth wire than spend $45 on that harness.with that being said I would like to know...

I have a 2009 Saturn Vue with factory fog light wiring but no fog lights. I bought a pair of fog lights from bling lights. Supposedly they are an exact fit. Instead of using the Rocker switch which the kit brought, I'm using the OEM switch so the Fog light icon appears on my Panel. Its has been...

Correct and wire it to 2ohm.. negative to negative, positive to positive..

The LPF is on 80hz, it dont goes any lower than that on the HU. It has more options on the EQ Pro section. i just dont want to mess with it and completely f*ck it up

yes it has EQ Pro. But i dont know on which setting to put it so all the bass comes from the sub. and so the speakers dont sound so bright

Polk Audio db651