Recent content by nismos14us

Pioneer has an older double din that does active, but I think one of hte main reasons of getting a double din is for nav.

I recently installed one of these in place of an Alpine PDX1.1000 that was running a pair of subs at 2 ohms. I switched it up and ran 1 Aura RPM2300 in stereo one channel to each sub. The subs are dramatically cleaner sounding while still providing the same amount of bass. The subs are...

SO is there a noteable difference if you swap left and right rca's in terms of output from the amp(s)?

What did you do with the wires for speaker output?

The PRS is 5 volt. When you measure it though you will almost never see anywhere near the voltage that the HU is rated for. If you have the volume all the way up and all settings maxed you may see over a volt, obviously that's not the way to run things lol. Seems like you may have a partially...

My system consists of the following: 2005 Nissan Altima SE-R: Source: Kenwood Excelon DNX9960 Line Driver: Tru Tech SSLD6i Front: Dynaudio System 360 Front Amp: Pioneer GM-X1022 Rear doors: Blaupunkt 8" Triaxial in rear doors Rear Deck: 10" Pioneer TS-W253F Diamond plates (2)...

The 5800 series is the lower line of Pioneer, if you owned something higher end from them I wonder if the same result would have occurred. I have owned them all, and currently run a Kenwood but have a 88prs stored away as it's one of the most versatile active decks you can get.

There's three in the 880/800 I believe. You can drop solder or solder in a strand of wire, but it's not the easiest thing since the fuses are about as thick as two hairs.