Recent content by McOpCo

No no. I get there are reducers. But I want to put 1/0 gauge in and have the solid piece that goes into amp also 1/0 gauge. Solder idea is good but would prefer the hardware piece of it's made.

I've seen these things that go on the end of wire to reduce them from a larger gauge to fit in an amp that will not accept that gauge of wire. Wire reducers I think. But what I want is the same thing but no reduction. I have an amp that accepts 0 gauge but I want to use the reducer like thing...

I have a 2006 Buick lacrosse. I'm installing a new head unit and am trying to figure out how I would find the car speed signal wire. Any help would be appreciated.

Using a jl hd 900.5 and a pioneer avic 8200 nex. I'm trying to get up to speed on the active vs passive. But I also don't understand how to properly set up crossover. But still looking on that.

Hey guys. I'm getting a new car and will be putting my system in it. Basically I'm trying to figure out my mid and high situation. I have stock rear speakers which are in the trunk deck. Because of this I'm planning to just remove them. So that leaves me with two front door speakers and two...

It's in now. Jl c2 650 coxials in doors. Jl hd 900\5 and a jl 10w6v3. Pioneer 8100 head unit.

I'm an idiot. I hadn't even looked at the AMP control panel. Took off the security plate and guess what???? Amp was in 2ch. Mode. Switched it to 4 and was in business.

Every speaker is on own channel as far as I can tell. Not bridging the amp head unit has rca's for front and rear.

Manual was my go to. It doesn't say anything helpful. What is network mode? Thanks for the advice. This is really pissing me off.

I don't know why but when I fade my head unti a pioneer 8100 NEX to the rear speakers all sound goes away. When I fade it back to the center or all the way front sound is fine in all speakers. So it's is like the head unit thinks the RCA's plugged into the rear channel are actually a...

Anyone know of any concerns I should have installing a system in my 09 Tahoe Hybrid. I realize I am somewhat limited because I can't upgrade alternator because there isn't one. Although I suppose I could possibly add a battery and an alternator solely to charge that battery effectively...

So I'm about to put a jl HD900/5 in my tahoe. I'm also putting in the jl c2650x coaxial in the four doors and I have 10w6v3 for the sub. The hd900 is running the whole show. So it's going to be 4ohm on the high pass but I don't know what to do or if it matters for the low pass. Because of the...

Thanks

So I have a 09 Tahoe that I am replacing the door speakers with JL Audio C2-650X. I am planning on powering them eventually with a JL HD600/4. So this would leave me with no way to power the tweeters. I don't really want to get a 6 chan amp. And since these speakers are coaxial do you think...

Do you guys think that the JL Audio HD Series HD600/4 is good for my 4 JL Audio C2-650X? I have a 2009 Tahoe and I am planing on replacing the door speakers with these and maybe just removing the tweeters well disconnecting them. You guys think that a good combo? It's really about all my...