Recent content by Kingstroker

dang double post. Not saying this isn't a good saw. It looks like they forgot to put 2 of the bolts in the legs on the left side

I have an older Craftsman( bought it new 18 yrs ago) and even though I should replace the motor with a better one it has been a good saw. It has the exact same cabinet and fence setup as this Rigid. My neighbor sells tools(Whittonsupply.com) and has for 18 years for the same company(almost all...

oops

Just took a look a the web site and didn't see anything about warranty matching on any product. Nothing about warrantees at all.

Last time the warranty issue with 3 Kings came up they claimed a lot matching but when I went to the web site it was on very few products. Checked several times in the weeks after that and no change. They made a lot of claims on the forum but not on the web site, nothing in writing to back up...

I would like to know what kind of trained technicians they have to evaluate electrical components to determine if they are covered under warranty?

These speakers where built to last and now built even better

Looking for the acrylic cylinder, bolts and flange. I can do without the flange and bolts but cylinder is a must. Forgot to mention the kit needs to be 8".

Memphis has a 300w 4 ch and a mono amp in the 400-600w range(not sure on these figures) both are slightly larger than a pack of cigarettes, very small and run very hot.

Wow, would have never thought that. Still wouldn't put it back in my ride.

found some Blues, thanks for the offers

I wouldn't power it up until someone looked at it

have whoever replaced the door fix the problem they most likely created.

mofo

polar is - or +. Make sure the lined(-) wire is connected to the neg post on each speaker and anywhere else you've added wire