Recent content by KaptainKenwood

HI, I am making a box for my 18 Inch. W3 series subwoofer. I was wondering if there is anyway to substitute 2 ports for the Recommended (one) that JL Audio specifies on their website. If there is a way is there a special formula to TUNE them two together? Any help would be a great help thanks!

I am in the process of making a slotted port enclosure for my JL Audio 18" the box has an over all volume of 5.02 cu ft. I want to tune it around 34 hz. which calls for a port size of 2.5 inch. wide and 14inch tall. This box is for everyday pounding, but I will take it to shows as well. I don't...

ok thanks... will try it

Are port plugs or removable port reducers a good idea for an enclosure that will be used for everyday bumping and then a competition every once in a while? If so, whats a good method for making one?

What are your opinions on the new line of Kenwood's excelon amplifer the Kac-X1R. Rated at over 1000 watts (rms) @ 1 ohm and 2400 watts peak. Bought one new for $200. Good deal or no?

Yea I have tried asking JL's tech. support line and they wont give me an answer, and neither will my local car audio dealer, They said they dont want to give away their "tricks of the trade because thats how they make a living" quote on quote... SO you think 5.5 would be better, ok I will see...

Can anybody out there tell me what would be a good frequency to tune my 4.75 cubic ft. ported box to . It will be housing a JL Audio 18w3. I will be using it for small competetions and daily bumpin'. Thanks!

Hello, I am in the process of making a ported enclosure for my 18w3. My enclosure size is 4.75 cubic ft. which is a little larger than JL Audio's recommended enclosure size of 4.5 cubic ft. I am getting to the stage where I am calculating the port size. I was wondering if someone could direct me...