Doxquzme's latest activity
-
Doxquzme replied to the thread Crackling Rears.Could the HU be the source? Get one of these (if for no other reason, it's great to test things with)... -
Doxquzme replied to the thread Shallow mounts.Prodigy NB3 series, probably the best bang for the buck shallow mount out there currently. https://prodigyaudio.com/Subwoofers/
-
Doxquzme replied to the thread Featured '24 Civic 24" subwoofer.Yeah, tried to figure that out just looking at the setup, gotta be pretty impressive no matter what.
-
Nick is running the 200.4 to his 24" https://stereointegrity.com/product/audi-avant-demo-car/ I have two CAB 2200s strapped on mine.
-
Doxquzme replied to the thread Featured Seeking Advice on My SQ Audio Build.Could the HU be the source? Get one of these (if for no other reason, it's great to test things with)...
-
Doxquzme replied to the thread Featured '24 Civic 24" subwoofer.Question? Are you running that 24" to the SiQ-200.4? If so, how do you like what it does as a subwoofer amp? Love the sarcasm, guessing you're...
-
Update... Hit 10k miles and decided to ruin the car. 12x20" hole. Hydrophobic mesh to keep out the rain. Exhaust heat wrapped...
-
Doxquzme replied to the thread Featured Premier DEH-880PRS.I have used that CD/Receiver and all manner of interations, to the current unit in my system, the DEX-P99RS. The DEH-P8xPRS series has a...
-
Doxquzme reacted to ThxOne's post in the thread Featured Alternator Whining Troubleshooting, can't seem to figure out the issue. with.Ahhhh I see the problem right away. You have a small amount of dirt all over the truck! The VERY first thing I would do is make that amplifier...
-
Doxquzme replied to the thread New system installed… maybe my expectations are too high?.The dual 12's have aproximatley 30% more cone area than a single 15", so they will play lower, and output will be higher, even on the same power...
-
Doxquzme replied to the thread What Did You Buy Today?.20mm & 30mm M8 nuts bolts and washers 6mm thick x 25 mm wide by 305mm long 99.7% T3 pure copper bar Going to make a raised 4" long (over 6mm...
-
-
Credit. I love spreading money across credit cards for payment.
-
Doxquzme reacted to EricF's post in the thread New system installed… maybe my expectations are too high? with.Thanks for the big write up. I'm looking at the invoice now, it says these aftermarket 2ohm speakers are compatible with the factory Bose system...
-
Doxquzme replied to the thread New system installed… maybe my expectations are too high?.I was also thinking out of phase, too; it'll totally kill the bass output.
-
Doxquzme reacted to RobGMN's post in the thread New system installed… maybe my expectations are too high? with.Try these things: 1. Disconnect the speaker wires form the amp. Assuming it's just two. Hold one wire to the the negative end of an AA battery...
-
Doxquzme replied to the thread What Did You Buy Today?.Because you can't have enough part storage organizers, right?
-
-
Doxquzme replied to the thread Featured Toyota head unit with amplifier..It's not uncommon for modern-ish HUs to have a single set of signal outputs, with a separate channel controller fed to a factory amp with...
-
a buddy recently asked me to do an old school build in a 96 2-door Tahoe. The gray boxes are a pair of MiniDSP 2x4 with the DC isolator.
-
He’s trained to only reply to the first post and apparently only to assist with food recipes.
-
Doxquzme replied to the thread JEEP Wrangler needs help.Absolutely, no point in getting 150-watt speakers and feeding them 10 watts. Get yourself a Stinger MT-600.4 or like type 150x4 channel...
-
Doxquzme replied to the thread AGM and Lithium together.You can run any set of batteries without anything in between if the charging voltage specs are identical or very close to being the same. The...
-
Just got this, was second hand less than half of normal price, I still need to test it, although was stated to work fine. Opinions on these seem...
