Recent content by coolername

So how does port area effect the bass? I've always heard more port area is a good thing. I'm running 2 15" subs with a RUB2500.

Sweet thanks man, appreciate the info. I've only found 6" ports max? PSP or Parts Express

How do you figure out how long they hafta be?? I'm planning on 2 aeros.

Why do people say "you need two 6" aeros" but don't specify the length??? I could have a mile long 6" aero and it fits that sentence........ Also every calc I've used says all I need for a 7 cube box is a single 6" aero about 7" long which is obviously wrong. What is going on? I know I need...

Thanks homie!

Cool thanks bro. Are the pins labeled? Lol I've been looking at the top face of the relay and it's painfully unclear to me

So 87 and 85 are 12v constant and ground (easy) The 86 is the remote wire input from the HU and the 30 is the power pin for anything I wanna run? That's where I splice my amp remotes as well as the fans right? I just pick up a socket for the relay and connect to the precut wires?

So I'm looking at this site for a relay to wire fans to my remote wire and I have zero experience with relays... none. Help? 12V Relays & Sockets in the Car Audio Department at Parts Express | 399

Why would it matter if I can access the old wires? Isn't it actually easier to just run new ones?

85 Cadillac Fleetwood! It's my lowlow so I've had the interior apart numerous times. So I figure I just cut apart all the speaker wires that were plugged into my deck and instead run em straight to the amp right? Cuz signal is from the RCA.

Thanks guys! I'm using Soundstream SST6x9 and 4x6.

So I have a decent grasp on the situation but I've never amped my speakers before. I'm looking at a 4 channel amp and four 3ohm speakers. The amp is a Soundstream RUB4.600 which is fine at 2ohms from what I hear but what will the final ohm load be after I hook up all 4 speakers? Each speaker has...

Which way do you point the aeros? Trunk car with the subs back. I know the aero needs to be at least 6" away from any wall but what about placement around the subs?

Ok and how did you find the correct port area? The 9-13 square inches per box cubic foot rule?

However I have looked at the PSP aeros and I think they're 15" with both flares on?