Recent content by capil

No I haven't only alpine and rockford but will look into them. Anyone else?

Buying new amps: Need a 4 channel and a mono block. 4 channel for the front stage/ Or could be a 2 channel. Need 150 to 170 watts rms at 4 ohm. Must be class AB And the mono must be 500 to 700 watts rms max. At 2 ohms and must be class d For the front stage I have DD 2 way components. 125...

Quite a bit or can order from sonic electronics. Just fiminding out what power people recommend giving it?

Either going to get a single idq10 version 4 (550 watts rms) or possibly the idq12 v4 (750 watts rms), what power would be best to power either the 10 or 12 inch?? Probably going to go with the new 12" and have heard a that the image dynamics idq subs go best underpowered or at what their rms...

Either going to get a single idq10 version 4 (550 watts rms) or possibly the idq12 v4 (750 watts rms), what power would be best to power either the 10 or 12 inch?? Probably going to go with the new 12" and have heard a that the image dynamics idq subs go best underpowered or at what their rms...

Check all your grounds Amp headunot and factory also check your voltages on the alt and battery

That's one sick setup! I would recommend going 3 way active with the bit one with optical in from the pure, I would personally ditch the rear speakers and use the money to get a bit one and optical.

I personally have two amps and have them grounded separately, it works fine no ground loops or issues, up to you, only with amps that pull higher current draw I would ground separate or to the same bolt and run another wire up. Have a good solid connection scrape the paint u should be fine

Yea just ground separate if u can, same gauge wire as ur power

If u have high wattage amps that would pull a lot of current from the alternator (over 100 amps) instead of using the ground of ur amp to the chassis, ur best to keep the amp ground there, and add another wire of the same gauge up to where the alternator or battery is grounded. This gives ur...

Are u running 2 amps? If ur running 2 amps ground each amp separate, shortest distance possible, less resistance. U can Use a distro block for power wire though,

Hi I'm in New Zealand and looking at opening a car audio shop in the future, will mainly focus on car audio retail and installs, in mid range - high end and also car alarms, tining etc. Tossing around names/ ideas of a shop names. Must be professional and not already be used. Any ideas?

Reviews on the image dynamics idq10v3 (500watt rms)

Looking at buying a single image dynamics idq10v3. Any review in it what does it sound like sq wise and HW much power would u guys give it? Its (500 watts rms) also anything better in its class? Looking at spending around $250 Cheers