Recent content by Bosshogg01

No, I don't have them yet. I currently have 2 12" rockfordfosgate P3's on a RF 1000 watt amp, and they just don't sound good to me anymore. I been researching different subs, and I've been going back and forth between Soundqubed, Crescendo, and Sundown. I seen a couple of videos done by GP Car...

Sorry for the confusion, the subs are rated at 1500w RMS, and the Q1-2200.2 is rated at 2300w at 1ohm. I plan to purchase (2) dual 1 ohm subs, and wire them to 1 ohm. If these subs can handle more, and there's an map that can supply the power, i'll take suggestions, and do some resewarch.

I'm thinking about upgrading my system to 2 Soundqubed HDC3-12's running off of a Soundqubed Q1-2200.2 amplifier. I have two questions 1. Is Soundqubed a quality brand with quality products. I'm used to buying the more "name brand" products like JL, Kicker, RockfordFosgate, MTX, etc. 2. If...

I'm planning on installing the "big 3", I have a question about wiring locations. From the research I've been doing 2 of the 3 locations remain the same. 1. positive from the battery to the positive post on the alternator 2. negative from the battery to the engine block/ground. What I keep...

I'm running 1800 watts. 1000 to a mono block, and (2) 400 watt amps for the mids and highs.

I just installed a second battery in my trunk, is it better for me to continue grounding to the chassis, or should i now ground to the negative terminal. I also read somewhere that if i do ground directly to the negative side of the battery i should install an inline fuse. Is there any truth to...

Thanks, I know it's not good to run wire smaller than what the manufacturer recommended, but would there be any major issues if I ran a larger wire to the amplifiers and used a 1/0 to 4 gauge reducer to connect to the amplifiers? Any feedback would be greatly appreciated.

is there a rule of thumb when running your power wire as to what size fuse to use? I plan on doing the big 3 upgrade with 0 gauge wire, and running 0 gauge to the back. Does my fuse size depend on the size of my wire, or how much power im running. I'm running 3 amps totaling 1800 watts.