Recent content by bentz69

Im looking to either replace my stock amp or add an additional amp to give my interior speakers a little more sound. Im not that skilled so the im looking for the easier route. I have a 04 acura TL. I replaced the front doors, tweeters, center channel and rear deck with infinity kappa speakers...

^good answer moron

Im using 1 Kicker 07CVR104. Im planning on a sealed box. The sub specs for a sealed box are a minimum of 0.8 and maximum of 3.0 cubic feet. Space isnt exactly an issue since it will be in the back of a suv. What will a bigger box provide? Any tips for this type of sub? I prefer sq over spl if...

^Yes Ive heard that before. How about the rockford r500-1 500w x1 @ 2ohms Any opinions on their prime series vs punch?

I want a simple setup to add to my trucks stock system for around 200$ for the amp and sub. Im thinking 1 10" kicker 07CVR104. Dual 4ohm vc, 400watts rms, 800 peak Id like to use a rockford p300-1 300watts x 1 @ 2ohms. Ive seen the birth sheets on this particular amp and its always above...

^thanks

I just switched subs from a rockford 15 hx2 to a alpine r 1023(2ohm dvc) and im still using the same rockford p5002 amp bridged at 500watts 4ohms. The amp was set to low pass mode at 320hz for the rockford sub. Thats what the shop had it set to. Any recommendations on where I should set the...

Im in the process of installing infinity 10.9t tweeters in the stock location on my car. However, the supplied crossover is too big to fit through the opening in the dash. There is no other way to get the crossover in there. The only way i was able to make it fit was buy removing the plastic...

ok guys I understand now I was looking at the amp and noticed it was set to low pass crossover and the frequency knob was set to 80 hz. Should the freq be set to a lower number for the alpine sub?

obviously Im a newb to this. So my rockford sub has been running incorrectly for a few years now. Oh well. I couldnt tell the difference. So the 1023 it is. Care to explain why a 4ohm amp needs to be used on 2ohm sub? I dont understand

lol thanks. The rockford 15" sub I have now is a 4ohm dvc sub and its running at 500 watts rms in bridged mode at 4 ohms. Why is this different?

^So then I want the 1043 and run it at 4ohms bridged?

I have a rockford p5002. Specs on the amp say 500 watts RMS in bridged mode at 4 ohms (4-ohm stable in bridged mode). Im using this right now bridged to power 1 rockford 15" hx2. I want to switch to an alpine 10" SWR to save space. I dont know if I should buy the 1023D or 1043D to use with this...

ill look into those. what I really love about the 15 is the deep tone you hear/feel. can I get that from a 12 or even a 10 in a smaller box?

Right now I have one 15" rockford hx2 sub in a 2.5 foot sealed box running off a rockford p5002 at 500watts rms @ 4 ohms bridged. Ive had this sub since 2001 and it still hits like the first day I bought it. Im trying to save some weight and space. This box/sub weighs at least 60 pounds...