Recent content by acprkit

  1. A

    Focal K2's sounding muddy - how to troubleshoot?

    I just installed a set of Focal K2 speakers in my Camry. The 4 in mid/woofer is in the door, and the tweeter is mounted near the A pillar,so the imaging is fine. However, the audio sounds muddy, as if I'm playing very low bitrate music. I am imputing high quality audio, so that is not the...
  2. A

    JL Audio Cleansweep 3rd party volume/input knob PS/2 connector

    Hi everyone I need to purchase a volume know for a JL Audio cleansweep. Its used for adjusting the output volume and for source (aux/radio) selection. I would prefer not to pay $45 asked by JL - its a PS/2 connector. Thanks!
  3. A

    Focal K2 placement in 2007 Camry - angled mounts?

    I just purchased the Focal K2 set, which includes a tweeter and 4 inch woofer. I will be putting them in the front doors of a 2007 Toyota Camry. The issue is that the door speaker is located in the bottom of the door towards the firewall - so the speakers fire into the transmission, pretty much...
  4. A

    Dissatisified with JL Audio Cleansweep

    Hi everyone, I have installed 4 Alpine Type S speakers and an Alpine MRP-f300 4 channel amp in my 2007 Camry. I want to keep the stock head unit, so I purchased a JL Audio Cleansweep (signal processor) to act as an interface between the OEM head unit and the amp. Everything is installed, and...
  5. A

    JL Cleansweep outputs two inputs at the same time

    Hi I just installed a JL Audio Cleansweep in my 2007 Toyota Camry with the stock head unit. The setup is: HU output is wired into the Cleansweep, which is then connected via RCA to an Alpine Mrp-f300 amp, which is connected to all 6 speakers (rear deck, doors, and dash). Here's the issue: The...
Top