Recent content by 4.698gt

the other speakers do not work. I have not gotten real involved into the kick panal area but I am going to start poking around the wires in the door and the kick panel to see what I fubared. I would assume that I would have to check the wires while the radio is on correct.

I had the speaker out while trying to play music. No good there, Non of the speakers in the car are working after I installed the drivers side speaker.

The harness I was pulling on was the original radio harness. Can I check the harnesses at the speaker with a grounded test light to see if current is following? I'm pretty much down to wiring chasing and making sure that everything is situated correctly it sounds like.

I was putting a pair of door speakers in the front doors of my girlfriends suzuki forenza after the original ones went kaput. I installed the passenger side and tested it and everything went good, sounded good. Installed the drivers side and not none of the speakers work and her power mirrors...

Thanks for the replies. Another question would be does the JVC unit send only bass singles or all signals to the amp?

So I have the amp installed and wired up but i pulled the headunit to relieze that I have only one pair of rca cables. The headunit is an older JCV unit model number KDLH910. Do I just use y cables or do y adaptors on a set of 4 channel cables? The amp is a PDX 4.100 by Alpine. Thanks for the help

You wouldnt happen to have a couple extra of those alpine speaker wire hook up pieces they use for the pdx amps do you?

Ok, so I have 1998 Mustang GT that originally had the mach 460 sound system. When I installed a new headunit, I bypassed the factory amps for the door and they have not been working since then because of the bypass. I have a small woofer in the trunk(the amp I am using is bridged, can I still...

I have done a search on this and couldnt come to any conclusion. Is there any specific size wire i should use for the remote turn on wire? Thanks Mike

I think it is for mikey060 avatar.

Post up you system that you have in your mustang. Let me know some details. Pics if you have them. Thanks

Thanks much for your help.

I just aquired a kenwood kfc2505 subwoofer. Its a ten inch the rms is 150 and the max is 600. Can someone recommend me a decent amp to power this thing. I know it isnt much but I am not looking to too much bass. Thanks much

I just got this headunit and hooked it up in my car. I am not getting any sound out of the speakers and it is absolutely driving me nuts with this thing. I have the volume one and the mute off. Any suggestions on the problems. The car is a 98 mustang gt