Sub wiring help

[JWBoz]

So I’m currently running Deaf Bonce sa302 d1 on Taramps bass 5k and xs power d7500. I’ve been searching for the sa3512r for months with no luck so I just ordered a American Bass GF1211 D1 12” and I’m wondering what is the best way to wire it for max spl. I know the Taramps put out rated at .5,1,and 2ohm but I can’t make up my mind on how to run it. I know 2 would be more efficient but I don’t really care about efficiency as much as I do about spl. And this is also my first direct lead sub and wanted opinions on what’s the preferred method for connections. I also am running 10g speaker wire. And the sub will be in a 3.3cube slotport box or I also have a 3.3cube aeroport with 2 4”x10” aeroports.
thanks in advance for the advice

Click to read more...

 

[1aespinoza Premium Member]

thanks in advance for the advice

If the amp puts out the same voltage on any specified impedance, then use it a 2 Ohms. If one coil goes bad, youll know right away.

 

[audiobaun 5,000+ posts]

If I had that sub and amplifier.. I would Run at 2 ohms
https://www.the12volt.com/caraudio/subwoofer-wiring-diagrams.asp?Q=1&I=12