Kenny's 1996 Chrysler LHS Worklog

[Spr0ket 10+ year member]

Spr0ket, think if I had Maaco take the emblems off and bondo or whatever the "holes" and repaint that section black it would match with the rest of the car? Think it'll be expensive? Think it'll be worth it?

I believe they would charge quiet a bit for it. You may be better off going to a small time body shop and have that done. Would probably cost less than $500 to do it. Check around for the pricing.

 

[Kenny Pollock 10+ year member]

Been a while, I'm enjoyin' the car quite a bit

Just ordered black molded carpet for the interior with new black floor mats. Interior work starts soon!

 

[bigbangtheory 5,000+ posts]

Good luck and keep the pics a coming! //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[Kenny Pollock 10+ year member]

The carpet shipped out today, should have it in a few days. Anything worthwhile to do while the old carpet is out? I've heard a lot about this "deadening."

Something is squeaking in the rear of the car when I pump the bass, it sounds like the license plate but isn't. It seems like it's coming from the rear fender. Any ideas?

 

[supa_c 5,000+ posts]

Probably the little air flap that lets air out of the vehicle so it doesnt become pressurized.

You should get a new muffler, that engine can bark pretty nice.

 

[Kenny Pollock 10+ year member]

Can you recommend a good muffler for my car?

 

[Chevyaudio 5,000+ posts]

I have a nice set of Flowmaster Super 40's on my silverado.

 

[supa_c 5,000+ posts]

Super 40's are LOUD

Id get something from magnaflow or another company since i hate the flowmaster sound.

 

[Jay_Rich 10+ year member]

They look good in black //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif I love mine......Nice choice of colour. Too bad my system was stolen and a whole **** load of stuff outta it!

Keep up the work man !!!!

Jay

 

[Kenny Pollock 10+ year member]

Thanks man, very sexy cars!

 

[Kenny Pollock 10+ year member]

I can't wait until Spring for Pioneer’s AVIC-Z1... it'll be hopping straight into my LHS.

What do you guys think about http://www.discountedwheelwarehouse.com/Store_Detail.cfm?ID=139323&InfoID=2505&ShowLarge=True for my rims?

 

[supa_c 5,000+ posts]

Not unless you drive a truck.....

 

[Kenny Pollock 10+ year member]

Why only a truck? They fit my car.

 

[Kenny Pollock 10+ year member]

Buyin' a set of 18" spinners...

 

[Dozy_production 10+ year member]

...if you get the spinners then make sure you get the fog machine to put under your car.