Wolfram audio

Roger dodge home skillet! Tell Colin to throw a decal in with my AG15 //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

Roger dodge home skillet! Tell Colin to throw a decal in with my AG15 //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

Click to expand...

Will do [emoji6]

Sent from my iPhone using Tapatalk

You da man!

Will do [emoji6]

Sent from my iPhone using Tapatalk

Click to expand...

how long u think it'll be before u get specs for ti subs? wonder if 2 would work in sealed?

how long u think it'll be before u get specs for ti subs? wonder if 2 would work in sealed?

Click to expand...

Hopefully this week sometime

Sent from my iPhone using Tapatalk

how long u think it'll be before u get specs for ti subs? wonder if 2 would work in sealed?

Click to expand...

There you go again. You don't need subs, you need more power.

Exactly!!! And one ohm

Click to expand...

yeah that 1's i was asking about.. right and 2 of those would be 1 ohm and if sealed no rise so i'd get over 1100rms.. just gotta see specs

There you go again. You don't need subs, you need more power.

Click to expand...

i need d2 sub or 2 2 d4 to get to 1 ohm which would be more power and cone area.. also a lower end like that wouldn't require as much power to get loud..

i need d2 sub or 2 2 d4 to get to 1 ohm which would be more power and cone area.. also a lower end like that wouldn't require as much power to get loud..

Click to expand...

duh....we all been telling you that. And now here you are regretting it lol

Ignore them gramps. I’m at 2ohm also. Because it don’t matter. And I really don’t need my amps power.

Ignore them gramps. I’m at 2ohm also. Because it don’t matter. And I really don’t need my amps power.

Click to expand...

well i do wish i had couple hundred more watts, probably most peeps could say that., but i do think if u have large amp it is better for amp and electrical to stay at lower ohm as u are.. i was trying to prevent light dimming and charging issues (until i could do wires) but i am trying to start big 3 slowly so i could upgrade something in spring maybe but can't get good answers on my batt terminal problem., factory negative wires are to short by like 1" to reach new batt terminal, only way to keep them is cut factory terminal off and connect them someway to few inches of i guess 4ga (like 2 wires in 1 butt connector or screw on barrel terminal or something cause my new terminal doesn't use rings so i'd just stick the wires in it.. so idk if it's ok to do that or if when i add 0 or 2 ga ground wire if i can just leave the factory ground wires and terminal just disconnected