Zapco 1100.1 problems..

J31Rob
5,000+ posts

CarTune Netwerk
Got a Zapco 1100.1.. it worked, now it doesn't.. power lighted flashes on & off..

Which I'm assuming that means protect.. but everytime it turns back on.. it sends power to whatever it's hooked up to.

Any ideas?

What is tha deal?

 
The small green light is flashing on and off? First, check that your ground and power connections are secure.
Set it up in 3 different cars.. does tha same in each vehicle.

Even ran it directly to a battery.. still flashes.

 
Ok...gonna have to be a process of elimination to solve this. What are you running and what's the load? Hopefully you're not running it a 1 ohm.

 
But when it WAS hooked up to subs (@ 2 ohm) it would turn on, bump tha subs.. fade out, turn on, bump tha subs.. fade out again..

& then it does that over & over..

 
Unfortunately, it sounds like it's power supply working, but outputs are blown. It powers up, detects unusual load from damaged outputs, which triggers protection and shuts down power supply. It needs to be serviced. If you decide to sell it, PM me //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

J31Rob

5,000+ posts
CarTune Netwerk
Thread starter
J31Rob
Joined
Location
Indiana
Start date
Participants
Who Replied
Replies
19
Views
1,877
Last reply date
Last reply from
J31Rob
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top