would this be a good set up for cdt's

  • 2
    Participant count
  • Participant list

lawntoyz
10+ year member

learning more everyday
i have a few questions about the set up iem thing about geting.

the compontens are going to be the cdt HD-62EF. and i was thinking about geting CDT Audio Euro Size Cast Frame High Definition Midbass/Midrange Speakers HD-6EF for my back in place of the 6x9's

1. do you think that this would be a good set up?

2. what amp should i use for every thing

3. should i put the midbass/ midrange speakers in some kind of enclosure around them? to make them sound better?

after i get this i think i am going to get RE SX's. any additional suggestions or comments are VARY welcome. that you so much!!!!!

 
1. do you think that this would be a good set up?
It will definitely be an improvement over stock. Quite a big improvement.

2. what amp should i use for every thing
If you want rear fill, a four channel amp that provides at least 50W per channel and fits your price range will be enough. If you ditch the rear fill (I am not a fan of rear fill myself but it is a preference thing) then you can get a more powerful and better quality two channel amp for the same money to just run the front stage. The higher power will allow for more "headroom" and better dynamics at moderate volume and has the potential to get louder. You will probably never turn it up enough to need more than 50W RMS but more power will lessen the chance of you overdriving the amp and cooking the speakers.

3. should i put the midbass/ midrange speakers in some kind of enclosure around them? to make them sound better?
Ideally you want to enclose them, but this isn't always possible or practical. For rear speakers that have their backs open to the trunk, the air moved by the subs will adversely affect their performance and longevity and they should definitely be enclosed for their own survival.

 
does any one know the rms of the HD-62EF compontens and the Audio Euro Size Cast Frame High Definition Midbass/Midrange Speakers HD-6EF . and what 4 chanal amp should i use for these speakers ?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
327
Time alignment is used to delay every speaker closer than the furthest to have the sound hit the listeners ears at exactly the right time. If this...
8
743
You can get close with tones, but music signal is all OVER the place in both frequencies and voltages. Like, if you listen to rap, the bass line...
3
823
Hello all. Used to come on these forum quite a bit. I used to compete in IASCA MECA etc. and placed 1st 2x with this setup. Anyway this is my baby...
0
786
Send me all the items. Once I receive them, I will verify everything in your classifieds. If someone buys them, I will ship out. You would just...
3
1K

About this thread

lawntoyz

10+ year member
learning more everyday
Thread starter
lawntoyz
Joined
Location
chelsea, mi
Start date
Participants
Who Replied
Replies
3
Views
672
Last reply date
Last reply from
lawntoyz
Screenshot_20240531-022053.png

1aespinoza

    May 31, 2024
  • 0
  • 0
Screenshot_20240524_202505_Samsung Internet.jpg

winkychevelle

    May 24, 2024
  • 0
  • 0

New threads

Top