Wiring 3 12” Fosgate Punch HX2’s at 4ohm DVC

series each pair of coils up to 8 ohm, then wire them all down to 2.66... if you invert one of the subs just flip the + and - where it goes into the amp and it will be "in phase" with the others

 
no, your subs have two coils each, wire them in series to make that one coil of 8 ohms, now if you have three 8 ohm coils/subs left, wire them all in parallel to get to 2.66 ohms, and just flip the speaker wire polarity on the inverted one and you will be ballin

 
So if just want to invert one polarity, i just invert where i highlighted in the pic below?

DVC_Series_3.gif


 
i would take the two remaining wires coming from teh sub and inverse the polarity there

but, i want to invert one sub. would it be possible to draw your example. i know i am asking too much, i trying to learn. please excuse.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

xDATx

10+ year member
Senior VIP Member
Thread starter
xDATx
Joined
Location
Los Angeles, CA
Start date
Participants
Who Replied
Replies
18
Views
1,080
Last reply date
Last reply from
xDATx
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top