yup, wire each sub down to 4 ohms and bridge each of them, assuming ur amp is bridgeable... sorry im not too familiar with lanzar amps, but you should be able to run it with no problem.
no you can not run a channel to each voice coil
you would be wasting your time trying to gain match a 4 channel amp
you would be wasting your time trying to gain match a 4 channel amp
- Thread Starter
- #4
Yes, my amp is bridgable, but how do you wire a dual 4 ohm voice coil down to 4 ohms? Or, if I can't run each channel directly to a voice coil, would it be better to just bridge the amp to 2 channels and only use 1 VC from each sub? I've never had DVC subs before, obviously, but I would like to use the Shivas with what I've got.
your best option as i see it is to wire each sub 8ohm (series)
and then bridge chs 1&2 to one sub and 3&4 to the other
i say this because i doubt your lanzar 4 ch is 2 ohm stable
and then bridge chs 1&2 to one sub and 3&4 to the other
i say this because i doubt your lanzar 4 ch is 2 ohm stable
- Thread Starter
- #6
Well, I guess I'll just look for a SVC I like and can afford, because I want to use all 800 watts RMS at 4 ohms. If I'm right, If I run 8 ohm subs, I'll only be getting half power. Is this correct?
Activity
No one is currently typing a reply...
