wiring 1 jl 10w6

[specie 10+ year member]

I'm planning on using my PPI a600 amp to power 1 10w6v2 (d4). I was wondering if I should wired it to 1 channel at 2 ohm or should I try to wire it at 8 ohm bridged?

Click to read more...

 

[helotaxi 5,000+ posts]

8 ohm bridged. 300W should be plenty for that sub and the amp will be happy. It might run at 2 ohms bridged but who knows for how long. Good luck getting that amp fixed if you blow it up.

 

[ultimate157 5,000+ posts]

Either one should get you the same power. 300x2 @ 2 or 1x300 @ 8 (assumed 1/2 of 4 ohm load)

8 bridged would likely give you best efficiency though.