WinISD

[soldiermedic 10+ year member]

How do I read the vent specs in this program? I figured out how to get the box specs, but I am at a loss on how to read the vent length, diameter, etc, and how to adjust the numbers so my vent will match the box since it comes up as a red number at first. I'll assume that the green is good, but you want that number closer to 0? I'm asking because I don't know how I got a 43 inch long port (seems longer than the box unless I'm reading it wrong).

Click to read more...

 

[406er 10+ year member]

click on the vents tab, select round or squre, enter the dimensions in and let it figure the length out

 

[soldiermedic 10+ year member]

click on the vents tab, select round or squre, enter the dimensions in and let it figure the length out

Enter the dimensions of what? If it's the dimensions of the vent, I have no clue how to interpret that since it seems that the vent is measured in a way that when I look at it, the vent is deeper than the box. So I guess I'm reading it wrong, and that's why I need to know how to read it.