Will this work or am I treading dangerous waters

[Wogic]

Hello, I'll get straight to the point. I'm upgrading my audio system in a 2009 toyota camry. List of all my parts are below.

• Power Acoustik eg4-1000 amp
• 4 6×9 kenwood 800w max 45w rms speakers
• 10" pioneer sub 400w max 250w rms
• 16 guage speaker wire
• 8 guage power wire

Now that we have the parts out of the way my question is. Can I wire my 4 speakers and sub on this one amp?
The amp does have a bridge option for a mono connection but I'm worried that connecting 4 speakers on 2 channels might be to hot.

I'm new to this so any help will be greatly appreciated. I will try to answer whatever questions I get thanks!

Click to read more...

 

[hispls 5,000+ posts]

The manufacturer claims that your amp will be able to do this but you will obviously lose the ability to fade front to rear and I'd expect it will probably run hot

 

[1aespinoza Premium Member]

any help

You should be ok, amp is designed to handle those loads. I would upgrade to 4 AWG. Also the sub must be single 4 Ohms or dual 2 Ohms. Sub wire at least 14 AWG. Like hispls said, it may run hot, but I figure that would happen at full tilt operation.

 

[Wogic]

Alrighty awesome ima try to install it. Wish me luck. Thanks for the replies guys!