where can i host pictures?

[Twistid 5,000+ posts]

i want to post a pic of some plans polecat made me cus i dont quite understand how to make the port and wanted your all opinion

but while im waiting i might as well explain.... the box if for S12L7, the box is 16" tall but the port is only 10" tall and 3" wide so does that mean ill have to cut out pieces to cover the top and bottom port tunnel inside the box???

i dunno how to explain it real good so ill just wait till someone replys with a good host, BTW the image is about 3.5 megs BMP format soo.... yea lol

Click to read more...

 

[squeak9798 5,000+ posts]

i want to post a pic of some plans polecat made me cus i dont quite understand how to make the port and wanted your all opinion

This forum has a gallery for it's users,

http://www.caraudio.com/vg/

and then there's always imageshack:

http://www.imageshack.us

 

[NegativeEffect1 10+ year member]

i want to post a pic of some plans polecat made me cus i dont quite understand how to make the port and wanted your all opinion
but while im waiting i might as well explain.... the box if for S12L7, the box is 16" tall but the port is only 10" tall and 3" wide so does that mean ill have to cut out pieces to cover the top and bottom port tunnel inside the box???

i dunno how to explain it real good so ill just wait till someone replys with a good host, BTW the image is about 3.5 megs BMP format soo.... yea lol

i use photobucket.com

with any hoster u choose you are going to need to make that pic smaller...use paint and convert it to a jpeg, if that didnt get it under 1meg then reduce the size

 

[RandyJ 10+ year member]

FYI, http://www.n[remove]iggahosting.com doesnt work //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

 

[Twistid 5,000+ posts]

there u go

so u see the port dosent extend long enough to meet with the roof and bottom, so would i have to cut pieces to cover the top and bottom to make it sort of like a tunnel? also could someone type up a cut sheet so i can goto lowes and get it cut, i dont know what lengths to cut and whatnot to compensate for wood thickness to match the inches in length, width, highth.... **** i think that makes sence

 

[Spr0ket 10+ year member]

That port is going to have quite a bit of noise. You may want to build the baffle so it's flush with the port walls (top, bottom, sides) otherwise you will have bad port noise. Also, with an L7, I would start with a thickness of .75" and go from there.

 

[Twistid 5,000+ posts]

well so i should get new plans then? i think these will be kind of hard to make, i want to build something so that the length of the port matches the highth of the box so all you have to do is cut the front shorter like 3" or so and boom u have a port and all u gotta do is mount a piece of wood to give it length ,

 

[Spr0ket 10+ year member]

It's not as hard as you think. Using a smaller drill bit, drill out the corners you will need. Draw the lines on the box using a straight edge. Cut the part out using a jig going from corner to corner. A router will also work in this case. You should be able to build the baffle board as one piece of wood. It will cut down on the possible air leaks.