What is the best way to wire this system?

- CD Receiver: Kenwood KDC-MPV6002

- 1 Amp: Kenwood KAC-X520

- 2 Subs: Kenwood KFC-W3009

- 2 Front: Sony XS-V1335X

- 2 Tweeters: Infinity 1001t

- 2 Rear: Rockford Fosgate FRC4206U

I currently have the front, tweeters, and rear being powered by the cd receiver. I am using bass blockers for the front, tweeters, and rear. I ordered the bass blockers from Crutchfield (I don't remember which ones they are).

I have the amp powering the subs. The subs are in the same enclosure.

How can I get the most out of this setup? How should I set the amp settings?

If you need any additional info, I have all the manuals in pdf form and all the specs in bmp form. I attempted to upload them here, but they exceeded the file size limit.

Thank you in advance!

 
ok, you wanna know how to wire it? or set the amp up?

to set the amp the proper way, youll need a dmm and a test tone disc, or download it from a website youll have to pm me for. also, how many watts into what ohms are you running to the subs?

 
well it all depends on what you are trying to achive.. is it all hooked up allready? how dose it sound to you?
i would ditch the rear tweet's.
It is all hooked up and it sounds pretty good. I was just wondering if I could change anything to make improvements. I only have 2 front tweeters.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Budrophious

Junior Member
Thread starter
Budrophious
Joined
Location
Knoxville, TN
Start date
Participants
Who Replied
Replies
10
Views
1,353
Last reply date
Last reply from
SethPhillips
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top