What amp to push these subs?

[LuRp 10+ year member]

I have now a 10" RF HE 200W RMS

I wanna add another in a sealed box.

I have a 160.2 punch running the single 10" now, so when i upgrade to 2 10"s what amp shouldi get? Im still a little confused as to how the wattage works with rms and peak... i dont wanna get an amp that too powerfull or one thats too weak. Also if someone could shed some light on as to what exactly is the difference in a 2 ohm load and a 4 ohm load? Also, what is the diff in mono mode? ok and 1 last question.. how do figure out where to set the gain on a sub or a reg speaker?

Thanks alot.. . -LuRp

Click to read more...

 

[audiolife 5,000+ posts]

welp i would suggest a 500d studio amp from memphis. its not too costly and if run in a series/parale config you will get good power to them .... other than that get the best class d u can afford that will run 1 ohm . http://www.mobileaudio.com/intdir/

go there and see what trips your trigger .

 

[CABLEBOI]

get the 400.4 punch or 400.4 power?