w3v2

My ex is running her v2's on a 1200.1 JBL

but was running htme on a borrow 1100 PPI tuned quite a bit down.

BTW Sealed all the way, unless you have a lot of room for ported and lot of time to tune them. (I'm still having problems tuning my V1's in a ported box)

THE SQ on them was nice, really nice (specially on the PPI). And they were very loud.

 
i have 12's and when i get my 2nd run i'll be running them w/the hifoncis z1000d...

i currently have 1 sealed 12 running off that amp at 750 watts @ 2ohms....

its sooooo **** good......

if u do it, make sure u do it right man.... those subs cost enough so u might as well get a good clean amp..

 
a jbl 600.1 will run 2 w3v2d2's not w3v2d's.... so be sure to get the right ohm load.... you'll have to put the subs in a sealed box b/c no subsonic filter.....

 
on the topic of subsonic filters.....My eclipse amp has a 20hz subsonic filter but I have a ported box tuned to around 37 hz....Is this safe for my 2 alpine type-r's????

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

greed

10+ year member
Member
Thread starter
greed
Joined
Location
ny
Start date
Participants
Who Replied
Replies
16
Views
976
Last reply date
Last reply from
limitkid7
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top