Two scv3ks or m4a/m4b

[dailyrider123]

I was wondering which one would you guys chose to go with and why. Setup is 4 12" 1250rms rated subs in a slot ported box tuned to 31hz in a 06 Tahoe. Goal is loud & efficient. If I use the two scv3ks they'll be gain matched @1ohm but if I use the did amp it'll be ran @.5ohm. This is for a daily situation and I listen to mostly rap

Click to read more...

 

[LosIsATool 5,000+ posts]

M4a/b is more power. Smaller. And .5ohm with rise will be good power.

 

[dailyrider123]

More power than two scv3ks? Or more power for the given wiring plans?

 

---------- Post added at 10:03 AM ---------- Previous post was at 10:02 AM ----------

 

It's two scv3ks or 1 m4a/b to be clear

 

[LosIsATool 5,000+ posts]

M4B is 7000 plus

Sorry. The M4A is a 7000. The M5 is more.

 

[dailyrider123]

So I'm better off with a m4b/a ? Whose a did dealer around here?

 

[wew lad 5,000+ posts]

the m4b is a 6k and thats what you'll get on average electrical... throw some caps, higher voltage, and lower impedance of course you'll get more like 7-8k but dont just flat out say its a 7k because its not designed to be

 

[LosIsATool 5,000+ posts]

the m4b is a 6k and thats what you'll get on average electrical... throw some caps, higher voltage, and lower impedance of course you'll get more like 7-8k but dont just flat out say its a 7k because its not designed to be

M4a was a 7k. And they are 12v amps

 

[LosIsATool 5,000+ posts]

So I'm better off with a m4b/a ? Whose a did dealer around here?

M4a which is discountinued. So the M5 is the new one. No online dealers for DD

 

[adulbrich 5,000+ posts]

Used M4a on a forum would be your best bet, imo

I wouldn't pay retail for an M5.

I wish I could afford Z2b's //content.invisioncic.com/y282845/emoticons/greedy.gif.5a53e6246569d7ab79867170f3b06629.gif

 

[dailyrider123]

So I might not need to find a m4a/b if you guys know anybody tell them I got 2 scv3ks I'm putting up as well and for a m5 I got the amps plus cash

 

[dailyrider123]

Would the m5 on stout electrical @.5ohm be too much for 12 d1 1250rms 3" inch coil subs?