Sold TC Sounds/JBL

Speakerman
10+ year member

Don't touch my willy
Rating: 0%
0 0 0
Well, here it goes. I noticed the other day that somebody tried to break into my truck by jamming a crow bar into the passenger door lock...They didn't get in, so nothing was taken.

However, I am concernced that my investments will be lost if I keep them installed any longer.

I appologize for the nature of this thread as it is a feeler so-to-speak.

A few specs

Fs 20.18

RMs ~2000

xmax 46mm+

Coil Single 2.5

This is the equipment I have for sale.

2 - JBL BPx2200.1 amplifiers, ~2400 Wrms @ 4 ohm --- 1-2 ohm stable. These amps are basically brand new, I will most likely be selling them for a loss, but as they say, my loss is your gain. If your not prepared to spend $700 on an amp, then there is no point in looking at these.

2070368_86_full.jpg


2070368_73_full.jpg


2 - TC Sounds Linear Motor Technology 15" prototypes, this is the same technology as the Sound Splinter RL-s, although they are vastly different speakers. This pair of subs is brand new, never installed. If you don't intend on spending $500 on a sub, then there is no point in looking at these.

2070368_100_full.jpg


2070368_90_full.jpg


I have tons of pictures on my CarDomain website. Please look there first before asking me to post more pictures. Thanks.

http://www.cardomain.com/ride/2070368

PM me if you'd like, but you will have a better chance of catching me through email at bsbl83@cs.com

 
dont mean to shit on your thread, but if those 15's were never installed, which ones are those wanging in that picture and on roe?
The ones in the videos were sent back due to a defect in the spider. The tinsel leads ripped through. TC is sending me a new pair with a beefier spider assembly similar to that of my prior pair of prototypes.

That was an honest question, and no offense was taken.

 
ah, i believe the rl-s 15's have the same issue, but are not being sold until its worked out.
I wouldn't doubt it.

My first pair of prototypes (with the brushed aluminum cone) had a thicker spider that never had any problems. This new pair had a thinner, more plyable spider assembly. When I send them back, I made **** sure they replaced it with the heavier duty of the two.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Speakerman

10+ year member
Don't touch my willy
Thread starter
Speakerman
Joined
Location
College Station, Texas
Start date
Participants
Who Replied
Replies
47
Views
2,638
Last reply date
Last reply from
pjm2211
IMG_20260506_140749.jpg

74eldiablo

    May 22, 2026
  • 0
  • 0
design.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0

New threads

Top