Stock car radio hook up to amp and subs

  • 2
    Participant count
  • Participant list
a stock radio cannot power subwoofers.  even if the stock system had an amp for a stock subwoofer. 

an external amplifier is required to power subwoofers.  this amp should have built-in high-level inputs and auto turn-on so you can interface with the factory radio.  A dedicated power wire ran to the battery and fused at the battery is required for the amp.  the amp needs to be compatible with the sub selection, but a monoblock amp that is 1 ohm stable should be fine.  it helps to understand how the subs are wired (how many connections on each sub) and what the exact model number is.  we're interested in the final impedance load the amp will see.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Car speakers dont last forever.. Neither do HUs. try a different speaker as stated and same Ohm Load. If it persist.. Its possible it will be an...
3
1K
Hello I also have a question I want to buy 160ah lto, i.e. 4 banks but I have a stock alternator of 140 a and a maximum load of 14.9 do you think...
0
258
If you are going to replace the HU, then the AC unit is not needed. As to which are good to use, I like the Kenwood Excelon, Sony, Alpine and...
6
763
Yep, that will mark the third iteration of teh X series. i figured that was in the loop as they have been running out of stock on the last...
11
925

About this thread

Stonecollins

CarAudio.com Newbie
Thread starter
Stonecollins
Joined
Location
Start date
Participants
Who Replied
Replies
1
Views
373
Last reply date
Last reply from
keep_hope_alive
received_1404248310277849.jpeg

Blackout67

    Jun 10, 2024
  • 0
  • 0
445981256_3731324230470906_9081536917273579948_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0

New threads

Top