Kazu iwamoto
CarAudio.com Newbie
i'm getting a slight static in the speakers. It's almost like I can hear the mic that the song was produced with. I know that this can be true as some song are just produced better than others, but I don't think this is that. Its unbearable, but to the trained ear its a little annoying when its a brand new setup.
Just to double check I played the same songs on my house audio receiver and there was a tiny bit of static still, so I don't think it can be 100% gone unless I want to get top level gear.
I am running an Alpine UTE-73BT head unit which runs three pairs of rca cables to my spare tire compartment where they connect unit a MRP-m500 mono subwoofer amp and a Kenwood excelon KAC-X520 4 channel amp. I am running my power, remote turn on, and ground on the left side of the vehicle and then my RCA and 4 pairs of speaker wire down the right.
The RCA cables are about 16ft and from amazon, and seem like decent quality, but really they were like 12-15bucks a piece. The speaker wore is also from amazon.
Would running speaker wire and RCA cables on the same side be causing this problem? Also would then the quality of the cable really dramatically affect the sound quality and leave the static noise?
What do you guys think?
Just to double check I played the same songs on my house audio receiver and there was a tiny bit of static still, so I don't think it can be 100% gone unless I want to get top level gear.
I am running an Alpine UTE-73BT head unit which runs three pairs of rca cables to my spare tire compartment where they connect unit a MRP-m500 mono subwoofer amp and a Kenwood excelon KAC-X520 4 channel amp. I am running my power, remote turn on, and ground on the left side of the vehicle and then my RCA and 4 pairs of speaker wire down the right.
The RCA cables are about 16ft and from amazon, and seem like decent quality, but really they were like 12-15bucks a piece. The speaker wore is also from amazon.
Would running speaker wire and RCA cables on the same side be causing this problem? Also would then the quality of the cable really dramatically affect the sound quality and leave the static noise?
What do you guys think?