before VC meltdown from me being an ashsole and abusing it into submission....lol
after....had to punch the cone to reveal the damage //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif
not good
broken tensils leads i repaired with new ordered tensil, soldering gun, and epoxy....the repair outlasted the life of the sub under harsh conditions, 4hp just underwent this same operation since i was owned by no SSF and the deck being lent to me while my touchscreen goes down to 10Hz.....certain notes here and there that were never there before cause some bottoming out, tensils didnt like it //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif
the xxx i just felt like being a dick, i figured itd blow the way i was treating it but i didnt care
the 4hp just bottomed otu a few times and didnt like it.... but where most ppl giv up i can repair and prolong the life of the sub, though i will eventually get it reconed with some new and better parts after i run this one into the ground, wont take long the spider isnt doing so good. when i get a new top assembly i'll treat it like a new born child....but thanks for the moral support matt foley