Recommend me an amp

  • 2
    Participant count
  • Participant list

NJJK70
10+ year member

Junior Member
Looking for amp suggestions for a single Polk MM1040DVC. It has dual 4 ohm voice coils and is rated for 350 watts RMS and 700 watts peak. I was looking at an Alpine MRV-500 a buddy has. Is that overkill for this sub? Thanks in advance!

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

One thing I’ve noticed about reading reviews is those who cannot spell offer very colorful and misspelled adjectives to describe products. Take...
3
2K
I’ve never owned them but have heard a lot of crossfire products and like them a lot.
22
3K
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
170
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
360

About this thread

NJJK70

10+ year member
Junior Member
Thread starter
NJJK70
Joined
Location
Sarasota Fl
Start date
Participants
Who Replied
Replies
1
Views
354
Last reply date
Last reply from
Jeffdachef
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top