RCA Cables losing signal

  • 1
    Participant count
  • Participant list

GoldenBuddha

Junior Member
Okay so im running two amps in my system, one is a R500X1D and the other is a Dual XPR520,

Im using the R500 to push a RF P3d412 and its just fine and im using the Output RCA on the amp to give signal to the XPR and it just seems a lot more quiet than the R500, im also using PX128's on the XPR520, any help would be appreciated!!

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

No make or model number on it? Do you have an exact picture of the rear and all its glory?
8
734
Use two sets of RCAs. One set for the Front channels and the other for Sub Output and into Rear Input on the amp. Turn off the Rear Filter on the...
5
718
Thanks a ton for your suggestion to my rather long query, I ll follow it and see how it works out. Thanks again
2
621
He'll be fine with any 4 ohm speakers, tuned properly. The focals are rated for 100 watts nominal and with the passive crossovers and power to...
6
770
Try this other test; get a 3.5mm headphone repair cable and connect it to the LC7i input. Connect that to your phone and measure. This will tell...
11
913

About this thread

GoldenBuddha

Junior Member
Thread starter
GoldenBuddha
Joined
Location
Lebanon,MO
Start date
Participants
Who Replied
Replies
0
Views
292
Last reply date
Last reply from
GoldenBuddha
1000008028.jpg

Mr FaceCaser

    May 20, 2024
  • 0
  • 0
1000008027.jpg

Mr FaceCaser

    May 20, 2024
  • 0
  • 0

New threads

Top