Question on wiring Pro60's with Crossfire Amp

[verg 10+ year member]

I currently have a crossfire 50.4 amp I am running to some eclipses. Obviously I need some more power than that for the bostons so I was thinking about bridging it to 200X2, would that be enough? I really **** at the math part in car audio, will this be 200 @ 4 ohms if i bridge it and since the bostons are 3 ohms it would be 266 X 2? Here is the tech sheet if any of you guys wold be so kind to help me. Just go to tech info on the top, amplifiers on the left, Tek amplifiers, 50.4.

http://www.crossfirecaraudio.com/frameset.asp

I just want to make sure that these will sound good. Later down the road I will get what sounds the best, but as of now I just want them to sound good.

Click to read more...

 

[Beat_Dominator 5,000+ posts]

SOunds like a good plan to me, just be careful with the gains //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[verg 10+ year member]

So am i correct with my math?? Since the Bostons are 3 ohms would my amp then be putting out 266 X 2??

 

[Beat_Dominator 5,000+ posts]

Well it's not garanteed that it'll put out that much, if I had to guess 230x2 is probably a safer bet.

 

[verg 10+ year member]

ok, I just wanted to make sure my math was correct and I was not going to mess it up. I was aiming at giving it anywhere between 200-300 watts as this is what I hear is the best to give these guys.