question about putting subs to close to each other

[Bagged96Chevy 10+ year member]

Will it hurt if i put my subs to close together?

i have a spot and i want to put my subs almost back to back would that hurt the sound or either sub?

Click to read more...

 

[Famous_78]

back to back, as in magnet to magnet? the magnets together would interfere im pretty sure, idk why you would wanna do this and i wanna see the box your doing it with //content.invisioncic.com/y282845/emoticons/needpics.gif.edd6d28e76618c28c46f343991bcced5.gif

 

[blackbonnie 5,000+ posts]

:thisthreadisfinewithoutpics:

and when you say back to back or are you talking about cone to cone?

 

[Bagged96Chevy 10+ year member]

I'm very limited on space and theres no pictures cause i have not done it yet its just the only way i can fit 2 12s in my truck

 

[Bagged96Chevy 10+ year member]

im refering to putting to subs in at an angle like /oo\

o being the magnet and \ being the cones

 

[blackbonnie 5,000+ posts]

how much space would you have between the closest point on the magnets?

 

[Famous_78]

im pretty sure you dont wanna put them too close have a lil room.

 

[Bagged96Chevy 10+ year member]

well im thinking maybe 1or2 inches ?

 

[Bagged96Chevy 10+ year member]

im trying to fit 2 12" L7's in my truck and it would be a huge task just to fit 10"s im talking a full fiberglass console just to hold 2 12"s

 

[Bagged96Chevy 10+ year member]

hhm after thinking about it i could do Cone to cone with about 5 inches inbetween them but i would prefer to mount magnet to magnet if i could figure out what distance is safe to do it like that?

 

[XanderMoser 10+ year member]

Could you just go with one 15"?

 

[Bagged96Chevy 10+ year member]

no not without removing my rear seat and i really dont want to remove it ...

i dont mind making a console that crouds whoevers sitting in the middle but i always end up with more than 2 people in my truck

 

[Volenti 10+ year member]

There's no problem with the magnets very close together, the motors are typically set up so that the magnetic path is in saturation (it as "magnetic" as it's going to get), another similar strength motor near by cannot effect it.

example pic;

 

[wilzyx 5,000+ posts]

you could face them towards each other and wire one out of phase so that one sub fires out as one goes in. dont know how thats gonna affect sound though

 

[spoonraker 10+ year member]

Or you could just use one sub........................