PRV Dust Cap Problem

[Savackz]

I have two problems with some 6.5 PRV 4mb200s. I have 4 of them, two of them are the new models, and two of them are the old model. But, one of the dust caps has a dent in it that I can't get out no matter what I do. Do you think I could just get some of these and get some e6000 and glue it over the current dust caps?

Parts Express 2-1/2" Poly Speaker Dust Cap

Parts Express 3" Poly Speaker Dust Cap

One of those, might just go with the 3 inch one just so I don't have to remove the current dust caps, just put this right straight over it and not have to worry that the 2.5" one is the same size as the current caps on them now.

I was also thinking if I just painted over the writing on the speakers that it would all just be black minus the one with the dent but I could get over that.

Suggestions?

Click to read more...

 

[Savackz]

...

 

[Massive spl]

Shop vac and svck dust cap out

Does the speaker have a pole vent where u can stick something in and pop dust cap back out?

Gorilla tape on dust cap and pull the dent out.

If all else fails poke a pin hole in the dust cap and then make alittle hook with the pin and pull the dent out.