problems with a audioque 750.1

[itsblown 10+ year member]

After hooking up a 750.1 for the first time fresh out of the box it doesnt seem to be putting out the power it should.

We checked all our grounds and followed the instructions on the website.

While adjusting the gain from all the way down to near all the way up the remote controll knob never showed clipping.

we had the pre out set all the way up and when playing a 35 hz test tone and having a dmm hooked up to the speaker terminals on the amp we saw 24.5 V AC with a 1.7 Ohm Load on it. that comes out to be some where around 300 watts ?

not sure if we just have un realistic expectations but after seeing multiple installs on the same exact amp as this I feel like it should be much much louder than what it is.

By the way this is hooked up to a brand new sa-8 v.2.

maybe the sub needs break in time to really get moving but I doubt it.

About to throw the sub on another amp to see if its the amp or just un realistic expectations. Im guesing the amp or I did something wrong installing it.

Click to read more...

 

[rebelfromva 10+ year member]

send me that sa8. problem solved? maybe needs break in time

 

[itsblown 10+ year member]

put the sa-8 on my amp it got alllot louder. somethings fuckky with our wiring or amp

 

[Dirtrider4eva 10+ year member]

check the voltage the amp is getting at the amps terminals, might be a fuse increasining resistance with a small internal break.

 

[itsblown 10+ year member]

Probably should of tested the voltage one thing that worries me is they tell you to set their remote controll to half way and then turn the game from all the way down to up untill the clipping lite hits. even playing sweeps it didnt start clipping with the gain pretty much all the way up? but I did throw the dmm on it and got 500 watts rms