Power Window Control Module

[Tedro]

has anybody wired one of these up b4, b/c i have 2 of them and i would like to use them but I am unsure on how they wire up. I have the wire colors for the car and the car had factory power windows. The car is a 2 door and i got 2 of them so that 1 is for when i arm the alarm the windows go up and the second one is to have them on a aux channel to roll them down. Is it posible to have them roll down or is my only choice to have them go up? on the conrtole module it has the wire schematic:

Pink= to accessory item

green= left motor

white= lest switch

orange= 500ma Activation

black= ground

red= + 12 volts

blue= right motor

brown= right switch

I know where to wire up all the wires to except the pink and the orange, I think that the orange needs to wire up to arm output of the alarm and the pink one i dont know what that wires to, or even if it wires to anything. also it says 500ma activation, the alarm i think has a -500ma output when armed. is the orange wire - or + activation? the alarm is a DEI alarm and I instaled it. I am very good with electronics but I am unsure on this item, i could figure it out myself but i dont want to waste my time in the vehicle in the heat sweating my @55 off!

Click to read more...

 

[Tedro]

nm, I figured it out, now when i arm my alarm my windows go up and then then i hit one of my aux my windows go down... I was just bored and started to playwith the windows...