Port the Perfects?

Yea, basically you make the enclosure so the SQ will **** and it will be loud as hell, and what will result is a nice sounding loud ass setup. Perfects sound nice in even the WORST enclosures. The spl for sq compromise with these drivers is non existent. I have a pair of 10" Perfects that crank as hard as a 15" L7 in a SPL ported box. THe Perfects are in a sealed box. Ported>not

 
i have my 2 perfect 12's in 3.5 net cubes tuned to 32 hz with pretty small port area and it sounds awsome. not the loudest but definatly louder than the sealed box i had for them and the sq is the same. just make the box... jl audio has really great tutorials that can help u with the box and the port and what not.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Yeah, saw that too, was like ??? wtf! They do know there stuff, I usually just roll with it!
13
1K
You could try to make the port longer, but there might be other reasons with the box won't extend lower, or even the sub. You'd have to reverse...
3
850
While that program is pretty neat, it assumes you know the values. I was just recapping the numbers you provided. RS recommends the following...
4
1K
Whoa, that will be one skinny port. The width of the back wall ports will be 1.08" wide (27.5mm), but the front port will be shared by 2 subs so...
5
999
Yup. That is the bread truck that Richard Clark built for MTX many years ago . 60 inch subwoofer. The problem was that the truck wasn’t...
14
2K

About this thread

LaBeLkilLs87

10+ year member
Member
Thread starter
LaBeLkilLs87
Joined
Location
Abilene, Texas
Start date
Participants
Who Replied
Replies
7
Views
675
Last reply date
Last reply from
guitar012345678
Screenshot_20240609-212906.png

Blackout67

    Jun 9, 2024
  • 0
  • 0
Screenshot_20240609-212805.png

Blackout67

    Jun 9, 2024
  • 0
  • 0

New threads

Top