port distance

[bryce-man 10+ year member]

was wondering what was more important the space between 2 ports on the same baffle or the space between the wall and the port

both ports are flared

(im thinking #2)

thanks

Click to read more...

 

[bryce-man 10+ year member]

short little question here

 

[Immacomputer 10+ year member]

Your question isn't very clear. What part of the port are you talking about? Also, is it hard to wait more than 9 minutes for a response? This isn't a chat room.

 

[Immacomputer 10+ year member]

Oh my God, I just asked a simple little question for you to clarify. What's with the delay!??!

 

[bdawson72 5,000+ posts]

You lost me slightly

 

[quakerroatmeal 10+ year member]

Oh my God, I just asked a simple little question for you to clarify. What's with the delay!??!

Haha I laughed at this. Reverse questioned.

 

[bryce-man 10+ year member]

haha well my last little question wasnt answered/ replyed to after it got off the main page lol

what i was asking was

ive heard of the rule that you have to have your port one diameter away from any wall

but what about the distance between ports.. does that need to be at least one port diameter or does it matter

talking about round ports ofcource

thanks

again

 

[Immacomputer 10+ year member]

This is speaking about the rear of the port, not so much the side.

The red dimension is what matters, not the blue. You should also keep the butts of the ports away from each other as well as the wall. It's ok for them to be side by side but face to face. Having the port directly against the side of the wall will not do much but maybe add a small amount of port length (like maybe less than an inch). Having them too close to the back will cause a choke point though.

 

[bryce-man 10+ year member]

cool thanks

just what i wanted to know