Please Help.

  • 1
    Participant count
  • Participant list

Wizard9056

Junior Member
I need to know how to size the amp for these subs.

ALUM10X

Quantity:3

800 watt RMS with 6 Ohm DVC's

Will be wired to get a 1 ohm load.

Do I need an amp that will Match the Combined RMS of 2400Watts? Should I go Half? Can Anyone recomend an Amplifier, or at least tell me it the Audiobahn A1500HCX will do the job?

Thanks !

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think you're gonna have to get good with fiberglass or something, or find someone with a 3d laser scanner that can 3d print or mold you some...
7
1K
Is this a blue or blue/white wire from the Kenwood? The ACC wire is red and although that should turn on the amp, it is not the prefered wiring...
1
756
The sound deadening is going to be more about preventing vibration from metal surfaces and adding unwanted noise. Does it have the JBL system...
1
741
It's called the K.I.S.S. preciniple ("Keep it simple, stupid!")... Takes the guesswork out of parallel/series wiring.
2
957
As for which signal to use, I tried all combinations and getting signal from the dash and front & rear doors is the only way the system sounded...
15
2K

About this thread

Wizard9056

Junior Member
Thread starter
Wizard9056
Joined
Location
Illinois
Start date
Participants
Who Replied
Replies
0
Views
827
Last reply date
Last reply from
Wizard9056
20240518_170822.jpg

Dylan27

    May 18, 2024
  • 0
  • 0
20240517_190901.jpg

Dylan27

    May 18, 2024
  • 0
  • 0

New threads

Top