Now noise

[RMF419 10+ year member]

I finally cleaned of the mess in the trunk with all the wires everywhere. I switched my subs and midbass to the Fusion amp and the highs to the Eclispe, and now I have a wine. Before, it was factory quiet, not a peep, something told me not to uck with it. I am going to switch them back, and I bet the wine will still be there. If so what can I do?

Click to read more...

 

[smoka 10+ year member]

most likely your amp grounds

 

[Varinabassing 10+ year member]

is there a thump when you cut it on nd off thn like up top ground is your rcas cross or run wit your power wire that will d it too

 

[AlterEgo99 5,000+ posts]

Cool! Are you getting a chardonnay or cabernet out of those amps???? //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[RMF419 10+ year member]

The ground was fine, no noise, until I switched the amps around. There is no thump when I cut it on and off. Today I got my fader together; left righ, front and rear, it must be some wires touching from time to time. Now it comes and goes. It does not get louder when I step on the gas. Although I can only hear it at very low levels. But before there was zero noise to my ears. I am going to try and isolate all the wires; power and signal in the trunk. Maybe I will take a picture and post., maybe you can see something. This is my first install, should have never uck with it.